geo.wikisort.org - River

The Glamorganshire Canal in South Wales, UK, was begun in 1790. It ran along the valley of the River Taff from Merthyr Tydfil to the sea at Cardiff. The final section of canal was closed in 1951.

Glamorganshire Canal
The Glamorganshire Canal at Nightingales Bush, Pontypridd.
Specifications
Locks	52
Status	Mostly filled in; part under A470 road; part footpaths.
History
Original owner	Glamorganshire Canal Navigation Co
Principal engineer	Thomas Dadford
Other engineer(s)	Thomas Sheasby
Date of act	1790
Date completed	1794
Date closed	1898, 1915, 1942, 1951
Geography
Start point	Merthyr Tydfil
End point	Cardiff Docks
Branch(es)	Aberdare Canal

v t e Glamorganshire Canal
Legend
Canal Head, Cyfarthfa 1 Lock 1, Merthyr Tydfil 2 Ynysfach Lock Dock 3 Parliament Lock 4-5 Glyndyrus Locks Dock and Upper Abercanaid Dock Abercanaid 6-7 Aberfan Locks 8 Pontygwaith Lock 9 Cefnglas Lock 10-17 Abercynon locks (8) Aberdare Canal 18-23 Abercynon locks (6) 24 Lock Isaf River Taff aqueduct The Basin 25 Ynyscaedudwg Lock Cilfynydd Pontypridd 26 Ty'n y graig Lock 27 Road Lock 28-29 Lock yr Odin Hopkin Morgan Basin 30 Trallwn Lock Brown Lenox Chain Works Basin 31-32 Ynysangharad Locks Treforest Head of Doctor's Canal 33 Dyffryn Lock 34 Dynea Lock Rhydyfelin Boat Dock 35-37 Treble Locks 38 Taffs Well Lock 39 Caegias Lock 40 Portobello Lock 41 Tongwynlais, Ton Lock 42 Llwynymellt Lock 43 Forest Lock 44 Melingriffith Lock 45 Llandaff Lock 46 College Lock 47 Gabalfa Lock Cambrian Yard 48 Mynachdy Lock 49 North Road Lock 50 Crockherbtown Lock Cardiff, The Tunnel (115 yd) Cut to West Dock 51 New Lock Sea Lock

History

Construction started in 1790; being watched over by the wealthy ironmasters of Merthyr Tydfil, including Richard Crawshay of the Cyfarthfa Ironworks, the canal was thought up as a solution to the issue of transporting the goods (iron ore, coal and limestone) from the valleys to Cardiff, where they would be shipped around the world. Thomas Dadford was hired to inspect and plan a route for the canal and, with support from Lord Cardiff, the canal was authorised by Parliament on 9 June 1790.

Almost £90,000 was raised in preparation of constructing the canal and would be linked to any works within four miles of the canal, through branch canals and linking railways.[1] However, during the few miles approaching Cardiff, the canal suffered from severe water shortages, resulting in goods not arriving in Cardiff on time. To solve this problem, a pump was introduced in Melingriffith, with the main purpose being to provide water to the canal from the River Taff. Located not far from the Melingriffith Tinplate works located directly between the River Taff and the Glamorganshire Canal, it was built in 1807, but the origins of the water pump are disputed; historians believe it was designed by either Watkin George of Cyfarthfa Ironworks (1793), or John Rennie (1795).

Construction

The Company of Proprietors of the Glamorganshire Canal Navigation was authorised to raise £60,000 in capital to build the main canal, with a further £30,000 if necessary,[1] together with branch canals as required, and feeder railways linking the canal to any works within 4 miles (6 km) of its course. These railways were deemed to be part of the canal itself, and so land for their routes could be obtained by compulsory purchase if required. Construction began in August 1790, when Thomas Dadford, a pupil of the canal engineer James Brindley, arrived on site, with Thomas Sheasby, his son Thomas Dadford, Jr., and a team of workmen. Construction started from the Merthyr Tydfil end. An extension from Merthyr to Crawshay's Cyfarthfa Ironworks was also built, although payment for it resulted in a dispute which was eventually resolved by arbitration. A plan to build a branch to the Dowlais and Penydarren Ironworks, which would have risen 411 feet (125 m) in only 1.75 miles (2.82 km) was dropped, and was replaced by two tramroads, one from each works.[2]

The Merthyr to Newbridge (later renamed Pontypridd) section was completed by June 1792, and the rest of the canal was progressively opened to Pwllywhyad (Treforest) in January 1793 and Taffs Well by June 1793. By this time the project was well over budget, and although the final section to Cardiff was opened on 10 February 1794, it was not well constructed, and there were several stoppages for repairs during 1794. The canal breached in December, but Dadford refused to start repairs without payment, despite the terms of his contract, and promptly dismissed his workforce and walked away from the job. The canal company attempted to recover £17,000 from the Dadfords, and had them arrested, but two independent surveyors employed by the engineer Robert Whitworth judged largely in the Dadfords' favour, and only £1,512 was refunded.[2]

The canal was around 25 miles (40 km) long with a drop of around 542 feet (165 m), requiring 50 locks. It clung to the western side of the valley down to Navigation (now called Abercynon) where it crossed the River Taff on an aqueduct, to cling to the eastern side for most of its route to Cardiff. A second act of Parliament was obtained on 26 April 1796,[1] which enabled the canal to be extended by half a mile (0.8 km), ending in a sea lock in Cardiff docks. This was opened in June 1798[2] when the event was celebrated by a naval procession and the firing of ships' guns [3] The total cost of the canal was £103,600, which included the costs of buying the land, as well as the contract with the Dadfords.[2]

Although the Dadfords left the canal under a shadow, their work was vindicated by Whitworth, and they went on to build other canals in neighbouring valleys,[2] while their achievement was summed up by John Bird in 1796: "The canal is brought through mountainous scenery with wonderful ingenuity"[4]

Operation

Richard Crawshay was the principal shareholder in the canal company, and seems to have used his influence to his own advantage, treating the canal as his own. His attempts to squeeze the profits of the other ironmasters led to them proposing a Tramroad from Merthyr to Cardiff, to compete with the canal. Crawshay resisted this, and the canal tolls were reduced somewhat, but the ironmasters on the east side of the Taff Valley soon built the Merthyr Tramroad, which opened in 1802 and linked their iron works to the canal at Abercynon, near the River Taff aqueduct.[5]

Water for the top of the canal was obtained from the tail races from Cyfarthfa ironworks, which had previously been fed back into the River Taff, so that it could be reused by the Plymouth ironworks. In order to safeguard this supply, all water discharged from the third lock was supposed to be fed into the Plymouth feeder, rather than the canal below it. This was a source of dispute for some years, with legal action instituted by both sides and the occasional bout of vandalism to ensure water actually flowed to the Plymouth works. The situation was eased with the opening of the Merthyr Tramroad, as there was less traffic on the upper section, and therefore less water used by the locks.[6]

The canal was profitable for many years. Dividends were limited to eight percent by the authorising act of Parliament, and so between 1804 and 1828 the profits were used to give refunds to the traders, periods when no tolls were charged, and others when they were reduced to one quarter of the rate fixed by the act. From 1841 railways began to encroach onto the canal's territory, when the Taff Vale Railway opened to Merthyr. The canal held its own for another twenty years, but in the 1870s the ironworks started to close, while some moved to the manufacture of steel.

1876 was the first year when the canal company was unable to pay the full eight percent dividend, and profits fell rapidly after that. The canal was sold to the Marquess of Bute in 1885, who made some improvements at the Cardiff end, but six railway companies were serving Merthyr by 1886, all competing for traffic. The upper sections, particularly the 4-mile (6 km) pound at Aberfan, was suffering from severe subsidence as a result of the coal mining. An inspection was carried out, and the canal was closed from Merthyr to Abercynon on 6 December 1898, to safeguard the village of Aberfan.[5]

Decline and closure

The takeover of the canal by the Marquess of Bute was a little too late to have any great effect. Improvements at Cardiff involved the construction of a new lock, Number 51, which raised the water level between there and Crockherbtown lock, so that the junction canal and the East and West Bute docks were all on the same level. The new lock was not included in the 1888 returns to the Board of Trade, and so must have been built after that date.[7] Traffic on the rest of the canal continued to decline, and when a breach occurred at Cilfynydd in 1915, the company decided not to invest in its repair, but instead built a wooden flume around the breach, so that water from the Elen Deg feeder could still reach the rest of the canal.[8] A further breach occurred on 25 May 1942, near Nantgarw and, although engineers examined the problem, no work was carried out.[9]

Cardiff Corporation moved quickly, and agreed to buy the canal for £44,000. This proposal was enshrined in the Cardiff Corporation Act of August 1943, allowing them to take control of the canal on 1 January 1944, and immediately declare it closed, most business having effectively ceased in 1942. However, Section 27 of that act prevented them from closing the final mile above the sea lock, while it was used by sand traders. An attempt to evict the sand traders failed when the Ministry of War Transport invoked section 27 and ruled that the sea lock pound must be kept navigable until 6 months after the present emergency ended. The war emergency was not declared to have ended until 8 October 1950.[9]

Meanwhile, the two sand and gravel firms continued to use the sea lock and the pound to carry on their business. However, the end came on the night of 5 December 1951, when a steam suction dredger, called Catherine Ethel and weighing 154 tons, crashed into the inner lock gates. The gates collapsed, and all of the water in the mile-long section (1.6 km) emptied into the estuary. The gates were never repaired and the difficult job of closing the canal was solved overnight for the Cardiff Corporation.[9]

Today

Today, limited traces of the canal remain, about one half being covered by the A470 Cardiff to Merthyr Tydfil trunk road, which was constructed in the 1970s.[10] Much of the Taff Trail between Abercynon and Merthyr Tydfil follows the line of the canal.[11] The section from Tongwynlais to the Melingriffith Tin Plate Works at Whitchurch has been retained in water and was used for fishing,[12] but is now the Glamorganshire Canal local nature reserve. In addition, there are a few bridges and locks which have not been destroyed.[13] There are also short stretches in water at Nightingales Bush and at Locks 31 and 32 in Pontypridd and there are plans for restoration here.[14]

A boat weighing machine, one of only four known to have existed on British canals, was originally installed at Tongwynlais and was later moved to North Road, Cardiff. The machine was presented to the British Transport Commission in 1955 and was re-erected at the Stoke Bruerne Canal Museum in Northamptonshire in 1964.[15] In 2013 it was moved to the National Waterfront Museum in Swansea.[16]

See also

• Canals of Great Britain
• History of the British canal system

References

Bibliography

External links

• Old Merthyr Tydfil: Glamorganshire Canal - Historical Photographs of the Glamorganshire Canal.
• "View of Bute Ironworks, Cardiff, oblique aerial view". Coflein. 1937 aerial photograph showing the canal in Butetown, Cardiff

---